INSTRUCTION MANUAL
Introduction
To get the most out of your new fan heater, please
read this manual and the safety instructions before
use.
Please keep the instructions in a safe place in case
you need to refer to them later.
Technical specifications
Voltage/frequency:
Power rating:
Power settings:
Variable thermostat setting (0-40° C)
Housing of steel plate and heat-resistant lacquer
Wall bracket enclosed
Requires at least a 13 A fuse
ENGLISH
230V - 50Hz
3000W
3 (40/1500/3000W)
Main components
1. Thermostat dial
2. Function selector with three power settings
3. Heating element
4. Legs
5. Cabinet
Special safety instructions
The fan heater is not suitable for use outdoors in
damp weather, in bathrooms or in other wet or
damp environments.
Please note that the fan heater can become very
hot and should, therefore, be placed at a safe
distance from flammable objects such as furniture,
curtains and similar.
Do not cover the fan heater.
Do not place the fan heater immediately under a
wall socket.
Do not connect the fan heater using an on/off
timer or other equipment which can automatically
switch on the device.
The heater must not be placed in rooms where
flammable liquids or gases are used or stored.
If an extension cord is used, it must be as short as
possible and always be fully extended.
You must not connect other equipment to the
same main plug as the fan heater.
If the fan heater is to be permanently installed, the
following instructions must be observed.
15