Manual Operation - Avinity Pure Image Bedienungsanleitung

Warning
• Connect the product only to a socket
that has been approved for the device.
The electrical socket must always be
easily accessible.
• Never connect multiple units of this
product in series.
5. Startup and Operation
Note — Maximum
Ensure that the mains supply socket is
protected with 10 A.
Note that the total power consumption of
all connected master
may not exceed 2300 watts.
Also note the type plates on the
backs of the connected
or the specifications in their operating
instructions.
5.1 Master/SIave Function
The master/slave function allows you
to switch up to 4 connected secondary
devices (slaves) on and off at the same
time by switching the on/off switch of a
primary device (master). This ensures that
none of the individual components of your
home entertainment system or stereo are
accidentally left on. An internal logic in the
power strip automatically
the primary device (master) is in standby
mode and thus switches
devices. It can also detect
device is switched on and can then
the slave devices on as well.
• Connect the Avinity master/slave
strip to a correctly installed and easy to
reach mains supply socket.
• Make sure that the slave
set to auto. The Slave
connected load
and slave devices
devices and/
detects whether
off the slave
when the master
switch
power
control switch is
ON LED is lit.
• Ensure that the sensitivity switch (13) on
the back of the plug strip is set to PC/
NB. The switching threshold for automatic
standby detection in this mode is 20 watts
(+/- 3 watts) for automatic switching off,
and is 35 watts (+/- 3 watts) for automatic
switching on. If the device connected to the
master socket requires much less energy in
standby mode, then switch the sensitivity
switch to netbook
switching threshhold for automatic standby
detection is 7 watts (+/-
automatic switching off and 18 watts (+/- 3
watts) for automatic switching on.
• Connect all of the secondary devices to the
slave sockets.
• Switch the slave devices on using their on/
off switches. Please refer to the operating
instructions of the secondary devices.
• Then plug the switched-off main device
into the master socket (max. 550 W).
• Switch on the main
• Check whether all of the slave
were switched on when the main (master)
device was switched
• Switch the main device
whether all of the slave
switched off when the main (master) device
was switched off.

5.2 Manual Operation

In manual operating mode, the master/slave
function is inactive and the Avinity power
strip acts like a normal power strip. You can
switch devices that are connected
Avinity power strip on and off manually.
• Make sure that all of the devices
switched off.
• Connect all of the devices with the Avinity
power strip as described in section 5.1
and note the instructions regarding the
maximum connected
• Set the slave control
Slave ON LED goes out.
The slave devices are no longer controlled by
the master device.
in this mode, the
3 watts) for
device.
devices
on.
off and check
devices were
to the
are
load.
switch to manual. The