veito blue s Montage- Und Gebrauchsanleitung Seite 38

EN
Cleaning the inlet water strainer
The inlet water is placed in the water inlet of the strainer's device and
should be checked and cleaned at regular intervals, not just because it is
clogged by the device's operation, or should be replaced with a new one.
Turn off the inlet water for cleaning.
Unscrew the front cover of the device and open the plug on the water inlet
by turning it in the disassembly direction. You can now access the inlet
water strainer in the nest. Remove the inlet water strainer from its place.
The inlet water strainer can be cleaned or replaced with a new one.
Do not use cutting and drilling tools which can damage the inlet water
strainer while cleaning. It is recommended that you use an old toothbrush
or similar tool. Place the inlet water strainer back into the water inlet and
screw it in place.
After opening the water valve, open the hot water tap and wait until there is
a regular flow of water.
Then open and close the hot water tap several times to clear the air gaps
that may occur from the system and the device.
-38-