Berger RMC 40 Bedienungsanleitung Seite 25

High (H)
Display
Switch on
12 V 12,4 V
24 V
25,7 V
What is the battery protection setting?
This function was developed to protect the battery and prevent deep discharge� If the measu-
red voltage is below the switch-off value, the compressor switches off to prevent the battery
from discharging; once the voltage is above the start value, the compressor resumes operati-
on� If the protection is set incorrectly or the battery is low, an E1 error may occur in the battery
protection� Charge the battery in good time�
4. Switch between °C and °F
• After you have switched to the cool box setting mode (see point 2), press the
the temperature scale; the corresponding symbol (°C, °F) flashes on the display panel; press the
"or "button to change the scale� Wait 5 seconds until the system has finished changing
the scale, the factory setting is °C�
5. Settings of the UV sterilizer
• When the cool box is switched on, the UV light switches on automatically� UV disinfection is
completed after approx� 30 seconds�
• When the lid is opened, the UV light switches off immediately�
• If you want to cancel the UV disinfection function, press and hold the
simultaneously after switching on the cool box� To restart the function, please repeat the
previous step�
Medium level is the default setting
Medium (M)
Switch off Switch on
11, 1 V 11,7 V
24,3 V 24,2 V
Switch off Switch on
10,4 V 10,9 V
22,8 V 22,7 V
GB
Low (L)
Switch off
9,6 V
21,3 V
button to set
and buttons
25