Synapse NeuRx Gebrauchsanweisung Seite 18

Stimulus Pattern Control Buttons
7.1.7
7.1.7.1 The STIMULATION PATTERN buttons allow the selection of
• PULSE
• A single stimulus pulse will be sent to the mapping probe.
• INSPIRATION INTERVAL
• A train of stimulus pulses will be sent to the mapping probe or
the activated output(s), for the INSP interval.
• BREATHS PER MINUTE
• A continuous stream of stimulus trains will be sent to the
activated output(s) at the set BPM rate.
Surgical Mapping Control Buttons
7.1.8
•
The stimulus can either be a single pulse or an inspiration train as
determined by the STIMULUS PATTERN CONTROL. The stimulus
parameter settings are determined by Channel 1 settings as
displayed while in STIMULATOR mode.
•
Prints out the maximum value of the current site, then increments the
mapped site counter.
•
The RESTART button resets displayed mapping site counters.
This button is active during SURGICAL Mode
for the SURGICAL MAPPING mode, and allow the selection of
or for the STIMULATOR mode
STIM
NEXT SITE
RESTART
or
18