Onkyo TA-R77 Bedienungsanleitung Seite 6

a clear leader section, tape travel is reversed the instant
the end Of the tape (including leader) is reached.
Notes:
• Because of slight physical differences between cassette
halves, cassettes recorded in the forward direction
should be played back in the forward
obtain the best results.
• Confirm the current tape travel direction
• The following explanations assumethat the cassette side A is facing outward.
• Due to the location Of the photo sensor, the transparent
result, the silent gap is about I second longer than the forward-to-reverse
Mode Selector Button
One side
TWO sides
(only
forward
to
reverse)
Continuous
direction to
MODE SELECTOR
setting with the direction indicator
leader must go by the heads before it is sensed for reverse-to-forward
switching gap.
Tape Travel
Only forward
Start
Only reverse
Start
When recording, the direction of tape travel only
switches from forward to reverse. To keep track
of which side is being recorded so that you do not
mistakenly use an already recorded side, it is a good
idea to always place side A facing outward for recording
operations.
GUIDE
before beginning playback or recording.
Playback
Press forward play
button .
Only side A (front)
played (once).
Press reverse play
button g. Only Side
B (rear) is played (once).
Start
Press forward play
button to begin play•
back in the forward
direction. Side A and
then B are played
which tape travel
automatically stops.
If playback is Started
the reverse direction,
only side B is played
after which tape travel
automatically stops.
Press forward play
button • Sides A and
B are played five times
or until STOP button
is pressed.
switching. As a
Recording
Press REC button
and—forward play
is
button at the same
time. Only side A
(front) is recorded.
Press REC button
and reverse play
button @ at the same
time. Only side B (rear)
is recorded.
Press REC button
and forward play
button at the same
time. Side A and then
after are recorded after which
tape travel automatically
stops.
If recording is started in
in
the reverse direction.
only Side B is recorded
after which tape travel
automatically stops.
Press >-forward play
button and REC
button at the same
time. Side A and then
side B are recorded
after which tape travel
automatically stops.
If recording is started
in the reverse direction,
only side B is recorded.
B