Onkyo TA-R77 Bedienungsanleitung Seite 4

See picture on page 2.
Front and Rear
Power Switch (POWER PUSH ON)
Headphone Jack (PHONES)
Eject Button (EJECT)
Cassette Door
Reverse Mode Indicator (REVERSE MODECD/Z/Z)
Record Indicator ( REC )
ReversePlay Indicator (—<REV)
Pause Indicator ( II PAUSE )
Forward Play Indicator
ReversePlay Button (
Press this button to play back a cassette in the reverse
direction. For reverse recording, press the
button at the same time as the reverse play button.
Rewind Button (
Press to wind the tape rapidly from right to left.
Fast Forward Button
Press to wind the tape rapidly from left to right
Forward Play Button (
Press this button to play back a cassette in the forward
direction. For forward recording, press the
button at the same time as the forward play button.
Filter Button (FILTER -—- ON/ AOFF)
Mode Selector Buttons
use these buttons to select the tape transport
for playback or recording. (seepage 6)
Dolby NR Button
Press this button to play back or record a cassette using
Dolby noise reduction.
Dolby NR Selector Button (BIC)
use this button to select Dolby B or C noise reduction.
System Connections
Ali connections should be made with the power OFF.
Hook up to amplifiers or other tape decks:
(REC) (PLAY)
Note:
Do not connect DIN cords and pin cords at the same time.
Panel Facilities
(——FWD)
REV)
REC
( )
FWD)
REC
(MODE SELECTOR
mode
AOI-IT)
TO REC/PB
terminal
DIN cord
For playback from
For recording on deck.
Tab Monitor
REV/FWD)
Indicates the presence or absence of erasure prevention
tabs on sides A and B of the cassette presently
The tab monitor lights to show which erasure prevention
tabs are in place (recording is possible).
Direction Indicator
Shows the current
Level Meter (PEAK LEVEL
Tape Counter (TAPE COUNTER)
stop Button (
Record Button
Tape Counter Reset Button (COUNTER RESET)
Pause Button
Auto Music Control System Button (AMCS)
Press to automatically
song in either direction.
Auto space Button (AUTO SPACE)
When this button
seconds long is inserted in the tape. See page 7 for
details.
Tape Selector Buttons (TAPE SELECTOR METAL/
HIGH/NORM)
Timer Operation
REC/OFF/PLAY)
Use this switch
audio timer.
at all other times.
Input Recording Level Control Knob (INPUT LEVEL
L-ZR)
gtl
Line In (LINE
Line out (LINE OUT (PLAY) )
DIN Terminal
Integrated Amplifier
0 000 0000
To tape playback or
auxiliary input terminals
For copying from
the
deck other
For copying
tape decks to the TA-R77.
Headphone Jack
Dynamic type headphones with a rated impedance
8 to 200 ohm range are recommended.
(TAB MONITOR RECORDABILITY
(DIRECTION)
direction of tape travel.
L/R)
STOP)
( REC)
( 11 PAUSE)
locate the beginning of the next
See page 7 for details.
is pressed, a blank section about 5
Switch (TIMER OPERATION
when the TA-R77 is used with
It should be left in the OFF position
See page 7 for details.
IN (REC) )
(DIN REC/PB)
Toe Deck
DECK
To recordi ng
f, tRt
terminals
To input
terminals
TA-R77 to
tape decks.
(dubbing) from other
inserted.
an
To output
terminals
in the