Sony VMC-P10 Gebrauchsanweisung Seite 4

Connecting the Display Unit to the Media Receiver Unit
• Be sure to unplug the Power Cords of the Display Unit and the Media Receiver Unit before connecting the
Display Unit to the Media Receiver Unit.
1
BLACK
Black
connector
Flow of signals
2
3
Screw the knob
clockwise with your
fingers and tighten it
until it is firmly
fastened.
Black connector
Display Interface Cable
Flow of signals
4
(GB)
WHITE
White connector
Connect the
cable to the
Media Receiver
Unit.
Display Interface Cable
BLACK WHITE
DISPLAY SIGNAL OUT
White
connector
Connect the Display Interface Cable
to the Flat-panel Display Unit.
Install the Flat-panel Display Unit.
Install the Flat-panel Display Unit on the dedicated
Wall-Mount Bracket or on the dedicated stands. (See
the instruction manuals of the Wall-Mount Bracket or
the dedicated stands for more information.)
Connect the Display Interface Cable
to the Media Receiver Unit.
Notes
• If you stumble over the Display Interface Cable, the
products may topple over or fall and cause injury.
Be sure to connect and secure the Display Interface
Cable properly to avoid these situations.
• Do not use the product with a distorted connector
or a damaged Display Interface Cable.