Warranty Conditions - Toparc Rc-Hd3 Bedienungsanleitung

UPDATE PROCEDURE
Download the latest firmware :
To download the latest software version, enter the serial number of your welding power source here:
https://update.jbdc.pro/getlastupdate
For robotic use of your welding power source, please consult this page:
https://planet.gys.fr/extranet/en/planet?page=automatisation
Then copy the '.egf' file to the USB stick (USB stick not supplied). This file must not be located in a folder or sub-folder on the USB stick.
The USB stick must contain only one '.egf' file, and must be formatted in FAT32.
Updating your product :
1. Switch off your unit using the On/Off button.
2. Plug the USB stick into the USB port.
3. Press and hold the two buttons in the middle of the HMI.
4. Switch on your machine using the On/Off button while holding down the two buttons in the middle of the HMI. When the screen displays one of
these messages, you can release the buttons.
System Update V__.__ Please Wait ...
Update in progress. When the update is complete,
the product indicates 'Update completed' and
restarts automatically after 3 seconds.

WARRANTY CONDITIONS

The warranty covers any defects or manufacturing faults for two years from the date of purchase (parts and labour).
The warranty does not cover:
• Any other damage caused during transport.
• The general wear and tear of parts (i.e. : cables, clamps, etc.).
• Incidents caused by misuse (incorrect power supply, dropping or dismantling).
• Environment-related faults (such as pollution, rust and dust).
In the event of a breakdown, please return the appliance to your distributor, along with:
- dated proof of purchase (receipt, invoice, etc.),
- a note explaining the malfunction.
RC-HD3
Versions are up-to-date
The product is already up to date, and will
restart automatically after 3 seconds.
USB Key Detection
The USB stick is not recognised.
Format your USB key in FAT32, and copy the
'.egf' file to the USB stick.
EN
9