Safety Instructions - Cecotec Airforce 2In1 Multifunction Bedienungsanleitung

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
- This appliance is designed for domestic use only and is not
intended for bars, restaurants, farmhouses, hotels, motels,
and offices.
- If the power cord is damaged, it must be replaced by the
official Cecotec Technical Support Service.
- WARNING: to recharge the battery, only use the removable
power supply unit provided with the tool, with reference
EA048-2150-200024DG.
- WARNING:
o Switch off and disconnect the tool from the mains before
cleaning or maintenance.
o Read the instruction manual.
o Do not expose to rain.
o Wear eye protection.
o Keep bystanders away.
- WARNING: Never allow children, people with physical,
sensory or mental limitations or a lack of experience and
knowledge and/or people unfamiliar with these instructions
to use the tool.
- WARNING: Never operate the tool while people, especially
children, or pets are nearby.
- The leaf blower is a tool designed to clean outdoor surfaces,
such as gardens and patios, using a powerful air flow to
blow leaves and light debris. It is not intended for blowing
heavy or wet materials, nor for indoor use.
- Do not overreach and maintain your balance at all times.
Always be sure of your footing on slopes. Walk, never run.
- WARNING: Do not touch dangerous moving parts before
12 AIRFORCE 2IN1 MULTIFUNCTION
switching off the tool or until they have come to a complete
stop.
- Always wear sturdy footwear and long trousers while
operating the tool.
- Switch off the tool and ensure that it is disconnected from
the power supply in the following circumstances:
o Whenever you stop using the tool.
o Before clearing/unblocking an obstruction.
o Before checking, cleaning or working on the tool.
o Before checking the tool for damage.
o If the tool starts to vibrate abnormally, stop using it and
check immediately for damage.
- Do not connect a damaged cord to the power supply or touch
a damaged cord before it has been disconnected from the
power supply, as damaged cords can lead to contact with
energised parts.
- Keep extension cords away from moving hazardous parts to
avoid damage and contact with energised parts.
- Connect the tool only to a power supply circuit protected by
a residual current device (RCD) with a tripping current not
exceeding 30 mA.
- Avoid using the tool in adverse weather conditions, especially
when there is a risk of lightning.
- The tool can be used by people with physical, sensory or
mental limitations or lack of experience and knowledge if
they have been given supervision or instruction concerning
the safe operation of the tool and understand the hazards
involved.
- Never allow children to use the tool. Keep the tool and its
charger out of the reach of children. Do not allow children to
play with the tool.
- The battery may leak under extreme conditions. Do not touch
AIRFORCE 2IN1 MULTIFUNCTION 13