Operation; Cleaning And Maintenance; Troubleshooting - Cecotec Airforce 2In1 Multifunction Bedienungsanleitung

ENGLISH

3. OPERATION

This product includes two tubes for two different uses:
- The wide tube collects air through its design and propels it, achieving a greater volume of
air. This can be useful when working in bigger gardens or covering a large area.
- The long tube boosts the air flow speed emitted by the leaf blower, thus achieving greater
power. This can be useful for spot cleaning tasks.
Fitting the wide tube
Insert the wide tube into the leaf blower body as shown in Fig. 2.
Removing the wide tube
Press the release button and pull the tube out to remove it from the leaf blower as shown in
Fig. 3.
Fitting the long tube
To attach the long tube, insert it until you hear a click as shown in Fig. 4.
Removing the long tube
Press the release button and pull the tube out to remove it from the leaf blower as shown in
Fig. 5.
Operation
- Insert the battery and make sure that it is completely fixed.
- To turn on the leaf blower, place the power switch in the ON position.
- To turn it off, place the power switch in the OFF position.
Note:
The tool will continue to operate for a few seconds after switching it off. Therefore, allow the
motor to come to a complete stop before using the tool again.
Adjusting the blowing speed
You can adjust the blowing speed using the corresponding switch (2). Fig. 6
Tips for use
- When the leaf blower is running, hold it firmly and move it back and forth slowly.
- When using this tool near a building, large object or vehicle, be sure not to point the tube
at them.
- If you are going to use the leaf blower in a corner, start in the corner and move the tool
gradually to a wider area.
98
AIRFORCE 2IN1 MULTIFUNCTION
Original instructions
Installing and removing the battery
Warning: Before using the blower for the first time fully charge the battery.
Replace the battery or charger immediately if the battery casing or charger cable is damaged.
Before carrying out any maintenance or repair work, make sure that the tool has been switched
off and the battery has been removed.
Installing the battery
To install the battery, align the guides with those on the tool and fit the battery. Then slide it all
the way forward until it locks into place.
Removing the battery
Press and hold the battery release button.
Hold the blower firmly and remove the battery from the handle by pulling it out.
NOTE:
If the battery cracks or breaks, whether or not it leaks, do not recharge or use it. Dispose of it
and replace it with a new battery. DO NOT ATTEMPT TO REPAIR IT.
Do not attempt to disassemble or destroy any of the battery components.
Do not attempt to open the battery.
If the battery leaks, the electrolytes released are corrosive and toxic. Do not allow the solution
to come into contact with your eyes or skin or ingest it.

4. CLEANING AND MAINTENANCE

- Before cleaning or maintenance, remove the battery from the leaf blower.
- Do the same when storing or transporting it. If the leaf blower is started by accident, there
is a great risk of injury.
- Use a dry or slightly damp cloth to clean the housing of the leaf blower. Avoid using harsh
chemicals. Make sure all parts are dry before using the tool again.
- To ensure safe and efficient operation, always keep the ventilation openings clean.

5. TROUBLESHOOTING

The leaf blower does not require technical maintenance, apart from regular cleaning and basic
care. If you detect any problems, do not attempt to repair it yourself and contact the official
Cecotec Technical Support Service.
ENGLISH
99
AIRFORCE 2IN1 MULTIFUNCTION
Original instructions