Meross MS600 Bedienungsanleitung Seite 6

l. Unfold the bracket
rotate it 90 degrees to the left.
2. Insert the Type-C power cable.
3. If wall installation
the power cord into the bottom lead
hole and secure the bracket in place.
4. If angle adjustment
secure the power cable in the slot at
the rear end of the stand, guiding the
charging cable in the desired direction.
5. Choose a side-mounting
between 1.2-1.8m above the ground.
Adjust the angle so that the sensor
directly faces the chest area where a
person typically sits or remains
stationary for extended periods.
Note: The core
presence sensor detects breathing
movements and may not be as
sensitive to the back, potentially
leading to false triggers or missed
detections.
6. Peel off the protective
side Of the adhesive tape and stick it to
the clean back
7. Peel off the protective
adhesive on the opposite
the sensor's base securely to the
desired location, applying
pressure for 60 seconds to ensure a
strong bond. When selecting an
appropriate position on the wall,
ensure that the
smooth, clean, and dry. Avoid surfaces
with paint or other coatings that might
cause the unit to detach
on the back
is required, insert
is needed,
height
function of the
film from one
Of the stand.
film from the
side. Affix
even
installation surface
over
and
is
time.