Shimpo RK-3E Bedienungsanleitung Seite 7

Start
Turn the power
switch on
Set the turntable direction.
faster
stop
Step the pedal forward from the
s t o p p o s i t i o n t o i n c r e a s e
speed.Step backward to reduce
speed,
Stop
stop
Step the pedal all the way back to
stop wheelhead.
Turn the power switch off.
Stop
Stop the wheelhead by stepping foot
pedal all way back.
Change the selector for opposite
direction.
Note: If you do not return pedal to the off position the
direction will not change even if the Fwd/Rev switch is
changed.
Operation Warning
Step the pedal all the way back
before turning the power switch off.
The wheelhead will not move if the
pedal was not all way back at last
power off.
Do not operate any switches
with wet hand.
The power indicater lights up.
Clock wise
Counter clock wise
The power switch has two functions. One is to turn wheel
on and off. The other is a reset function. This wheel has
a safety feature for over load. In order to reset, operator
must switch off and on again. (Don't forget to step the
pedal all the way down before turning switch back on.)
Switch the on/off-breaker switch to
the off position (refer to diagram).
Return the foot pedal to the off
position (refer to diagram).
Turn the power switch back on.
Note: If the pedal is not returned to the off
position before the power switch is turned
on the wheelhead will not turn; your wheel
will not respond.
Mainteinance
Turn the power switch off and unplug
the power cable for cleaning, testing or
adjustment. (It is recomended to do the
same if the wheel will not be in use for a
long period.)
DO NOT POUR WATER ON THE
WHEEL TO CLEAN IT.
wheel down with a damp sponge or
cloth. (Splash pan can be saturated if it
is removed from the wheel.)
Foot Pedal Replacement
Using the wrench provided,loosen the
stopper bolt if the wheelhead does not strat
after replacing the foot pedal.
stopper bolt
Lock nut
Wipe the