Leg Installation; Power Connection - Shimpo Rk-3E Bedienungsanleitung

Foot Pedal Installation
Insert the female connector to the male connector
after positioned correctly.
Fasten the connecter by turnning the screw cap.

Leg Installation

Place the wheel vertically on
the carpet as displayed in the
picture to the right.
Remove the rubber caps.
(keep those for future use.)
Insert the leg as the drawing illustrates.
Adjust the height evenly on all three legs. Tighten
bolts with allen wrench.
position of bolts
Bolts
M6 x 12
Place the wheel horizontally after tighting the bolts.
Splash Pan Installation
the seal frange.
under the seal frange.

Power connection

allen wrench
Insert splash pan A into the groove under
Insert splash pan B into the groove
Join splash pan A into splash B
Connect the power cable to a 230v
single phase AC power outlet only.
Do not connect many power
cables to the same outlet.
May cause fi re by
exceeding outlet
capacity.
Make sure the power switch is
off when you plug the power
cable into the AC outlet.