Programming The Remote - Sony KDS-70R2000 Bedienungsanleitung

To connect Do this
Digital audio Connect to the DIGITAL OUT
(PCM) component (OPTICAL) socket using the
K
Optical audio cable.
Note
DIGITAL OUT (OPTICAL)
The
socket only supports digital terrestrial
signals.
Hi-Fi audio Connect to the audio output
equipment L
sockets
from the TV on Hi-Fi audio
equipment.
to listen to the sound
Programming the
remote
This remote is preset to operate Sony TVs, most Sony
DVDs, VCRs and AMPs (Home Theatre, etc.).
To control VCRs and DVDs of other manufacturers
(and some other Sony VCR, DVD and AMP models),
do the following procedure to programme the remote.
Note
Before you start, look up the three-digit code for your brand
of DVD, VCR or AMP from the "Manufacturer's codes" on
page 46.
1
Press and hold the DVD, VCR or AMP
function button you want to programme on
the remote, then press
function button pressed down.
The selected function button (DVD, VCR or
AMP) will flash.
2
Press the number buttons to enter the
three-digit manufacturer's code number
while the button is lit. If code is not entered
within 10 seconds, you must perform the
step 1 again.
3
Press .
When the programming is correct, the selected
function button will flash twice, and when not, it
will flash five times.
1
2
1
3
, keeping the
Continued
45
GB