Sony LF-PK1 Kurzanleitung Seite 17

Check the Base Station NETWORK LED.
Check whether the Base Station NETWORK LED is turned on.
When not turned on:
Make sure the router power is turned on and the LAN cable is
connected correctly.
Put the Base Station into Setup
Mode (Registration Possible)
Keep pressing the SETUP MODE button on the rear
panel of the Base Station until the SETUP MODE
LED starts blinking.
 Tip
Make all settings up to "Connect Your Computer to the Base
Station to Watch Video" (page 14) while the SETUP MODE LED is
blinking.
Note
The Setup Mode (registration possible) is available for 5 minutes. If
the SETUP MODE LED stops blinking, keep pressing the SETUP
MODE button again until the SETUP MODE LED starts blinking.
GB
13 (GB)