Samsung SWA-9000S Benutzerhandbuch Seite 8

• When connecting the speaker cables to the surround speakers, follow these steps:
1. Match the speaker cable connected to the grey jack to the speaker with the grey label.
2. Match the speaker cable connected to the blue jack to the speaker with the blue label.
3. Insert the red and black coloured ends of each speaker cable into the red and black jacks of
the appropriate speaker.
• The labels are on the backs of the speakers.
2. Check the standby status after plugging into an electrical outlet
Plug the Wireless Receiver Module power cord into an electrical outlet and into the Wireless
Receiver Module to turn on the Wireless Receiver Module. The LINK LED indicator (blue LED) on the
Wireless Receiver Module blinks. If the LED does not blink, refer to step 8 on page 11.
Attach the Toroidal Ferrite Core to the Power Cord of the Soundbar
(Applicable only when connecting the SWA-9000S and MS series Soundbars/home
cinemas.)
Bottom of the Soundbar
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
ID SET
POWER
POWER
Attach the Toroidal ferrite core to the power cord
of the Soundbar to help prevent RF interference
AC 100V~240V
4A~1.66A from radio signals.
POWER
OUT
(For TV)
1. Pull the fixing tab of the Toroidal ferrite core to
POWER
IN
2. Make two loops in the Soundbar's power cord.
3. Attach the Toroidal ferrite core to the Soundbar's
AC 100V~240V
DIGITAL AUDIO IN
4A~1.66A
(OPTICAL)
POWER
HDMI IN
OUT
(For TV)
WIRELESS
HDMI OUT
POWER
AUX IN (TV-ARC)
IN
ENG - 8
STANDBY
STANDBY
LINK
open it.
power cord as shown in the figure on the left, and
then close it by pressing it until it clicks.
• Ensure that the ferrite core is attached as
close as possible to the power plug of the
Soundbar.
LINK
Blue blinking