Measuring Method; Measurement Benchmark Setting; Single Measurement; Continuous Measurement - Wohler LD 400 Bedienungsanleitung

6

Measuring Method

NOTE!
The meter will only measure, when the laser pointer is switched on. After the measure-
ment the laser pointer will always be switched off.
6.1 Measurement bench-
mark setting
6.2

Single measurement

6.3 Continuous Measure-
ment
(long press)

Press the benchmark-key to enter into setting
of switching between front benchmark and
end benchmark.
Example:
If you put the meter in a vertical position on the
floor to measure the room height, the end bench-
mark must be selected.

Point the laser to the target and press the
READ-key.
The result of the linear measurement is shown in
the result line.

Point the laser to the target and long press the
READ-key, until you hear a continuous beep.
The meter enters the continuous measuring
mode. In this mode the current reading appears in
the result line, and above the minimum reading
and the maximum reading.

Press the READ-key again to exit continuous
measurement mode.
Measuring Method
35
EN