Vertical Position - Stix Tool In-12L Bedienungsanleitung

Air Tire Bead Seater  User manual
5. Take the other hand and quickly turn the air release valve to open, releasing air into the tire.
6. Once you have successfully seated the tire, connect an air supply line to the tire valve to complete tire
inflation to correct pressure.
Using the bead seater for vertical position for tire/wheel
WARNING! This method should only be used when there is a large gap between the wheel rim
and tire bead or if the tire is too heavy.
1. Position the tire and wheel so that it is tilted slightly back and secure it with a tire wedge. Make sure the tire
and wheel are supported away from the wall to be sure once inflated the tire and wheel do not fall forward,
causing injury.
2. The back bead of the tire (furthest from operator) should be seated against the wheel rim trapping out any
air. The front or wide flange of the wheel should be facing the operator with the tire valve stem positioned
at the bottom of the tire.
3. Rotate the barrel so the barrel flange is underneath (on the opposite side if the air release handle).
4. Firmly hold the bead seater by the handle and position barrel at an approximate 45 degree downward angle
and place the barrel flange on the edge of the wheel, opposite the tire valve, into the opening between the
tire and rim.
5. Take the other hand and quickly turn the air release valve to open, releasing air into the tire.
6. Once you have successfully seated the tire, connect an air supply line to the tire valve to complete tire
inflation to correct pressure.
MAINTENANcE
Check the bead seating tool is regularly for damage or signs of wear and ensure the tank is inspected inside and
out on a yearly basis. Drain the bead seating tool regularly. To do this, hang the bead seater up with the barrel
positioned downward and open the air release valve. Always store the bead seater in a cool, dry place, hanging
by the handle with the air release valve open to ensure any built-up moisture drains from the tank. This also
protects the barrel and attachments from damage.
NOISE SPEcIFIcATIONS
Assuming the bead seating tool is used on average of 6-10 times a day, Average noise level equivalent is ap-
proximately L/AEq <70 dB. Peak C weighted instantaneous sound pressure = 135 dB =112.46 (measurements
were taken discharging the bead seating tool into free air. The noise level is reduced when discharged at a tire
and rim).
horizontal position
4

Vertical position