HOMCOM 800-212V70 Bedienungsanleitung Seite 4

EN
2. Fill the jug with the required quantity of water (at least 0.6L, and a maximum of 1.7L).
Never fill the water boiler over the "max". Otherwise the hot water can spatter out of the
base.
3. Refit the lid. Always fit the lid when boiling the kettle.
4. Put the power base on a stable, level surface.
5. Plug the power base into the wall socket.
6. Put the kettle on the power base
7. Move the switch to I.
8. The light will come on. The kettle will start to heat.
9. When the water boils the kettle will switch off.
10. To switch off manually, move the switch to 0, or simply lift the kettle off the stand.
WATER TEMPERATURE GAUGE
The water temperature gauge constantly shows you the temperature of the water inside
the kettle. Use the gauge when you are making drinks that require different water
temperatures like green teas, white teas, coffee, etc. The gauge will not work if there is
insufficient water in the kettle (less than the minimum level).
GENERAL
When you lift the kettle, you may see moisture on the stand. Don't worry – it's the steam
used to switch off automatically, which then condenses and escapes via vents under the
kettle.
Overheating safeguard
The jug kettle is fitted with an overheating safeguard. This will switch off the jug kettle if it
is operated without (sufficient) water. Allow the jug kettle to cool down for at least 10
minutes before using it again.
CLEANING AND MAINTENANCE
Remove the plug from the wall socket, and allow the appliance to cool.
•
Clean the jug with a damp cloth. Never immerse the appliance in water. Never put the
•
appliance in a dishwasher. Make sure that the electrical connections do not become
damp.
If the interior of the jug has become severely discoloured, then the best way to clean it
•
is with a damp cloth and a little washing soda. After cleaning, rinse the jug very
thoroughly.
ATTENTION:
• Never use corrosive or scouring cleaning agents or sharp objects (such as
knives or hard brushes) to clean the appliance.
• Before cleaning, make sure that the appliance is not connected to the power
supply and that it has cooled down.
4