RONDELL RDE-1701 Betriebsanweisung Seite 15

– Remove the tray (5).
– Remove the remaining products from the removable
plates (10 and 11), wash the plates (10 and 11) with warm
water and a neutral detergent, then dry thoroughly.
Notes: removable plates are dishwasher-safe.
– Wash the tray (5) with warm water and a neutral detergent
and then dry it thoroughly.
– After cooking fish brush the frying plates with lemon juice
to remove the fishy flavor.
– Clean the grill body with a soft, slightly damp cloth and
then wipe it dry.
TROUBLESHOOTING
Malfunction Possible cause
One of the frying plates Removable plate is not installed properly
doesn't heat up
Electrical wiring of the unit is malfunctioning
Electrical control unit is malfunctioning
Heating element is malfunctioning
The unit does The power plug is not completely inserted
not switch on into the socket
Mains socket is malfunctioning
RCD actuated
The display doesn't show The meat thermometer is malfunctioning
the temperature readings
Electrical control unit is malfunctioning
when you connect the
meat thermometer
The frying plates heating The temperature sensor works improperly
doesn't switch off
E1 appear on the digital Open circuit between NTC and control panel
display
E2 appear on the digital Short circuit between NTC and control panel
display
– Install the removable plates (10 and 11) and the tray (5)
back to their places.
– Do not use abrasives, solvents or metal sponges for
cleaning the removable plates (10 and 11) and the grill
body, as they can damage the non-stick coating or the
outer surface of the grill body.
– Never immerse the grill, power cord and cord plug into
water!
Attention! To avoid electric shock, do not immerse the unit
into water or any other liquids.
Solution methods
Unplug the unit.
Install the removable plate until clicking and switch
the unit on again
Contact the service center
Contact the service center
Contact the service center
Insert the power plug into the mains socket
completely
Connect the unit to another socket
Unplug the unit. Eliminate the possible cause of
the RCD actuation.
If the problem remains, apply to the service center
Replace the thermometer with a good one
Contact the service center
Contact the service center
Disconnect the power supply and contact the
service center
Disconnect the power supply and contact the
service center
15
ENGLISH