Foppapedretti REK Montageanweisungen Seite 7

IMPORTANT! READ CAREFULLY
AND KEEP FOR FUTURE REFERENCE
WARNINGS
• WARNING: Only use the REK adapters for Divo with the Divo pram.
• WARNING: Only the REK i-Size car seat can be attached to these adapters.
• ATTENTION: Always make sure the REK i-Size car seat is correctly attached to
the pram frame before use. When lifting the seat, upwards, it must not detach
from the pushchair frame.
• When not in use, keep the adapters out of reach of children.
• IMPORTANT: The REK i-Size car seat must only be attached to the pram frame
facing forward (fig. 01).
• WARNING: Read the Divo pram and Divo car seat instructions carefully before
using the product.
INSTALLATION ☞
Before installing the adapters on the pram, the seat must be removed.
Fitting the adapters (fig. 02): Align and insert the right and left adapters into their
seats on the pram frame.
Press until you hear a click, this will indicate the correct attachment.
WARNING: Always make sure that both adapters are correctly attached
to the frame before use, by lifting them they must not come loose.
Removing the adapters (fig. 06): Press button 'a' to remove the adapter.
Mounting car seat REK i-Size (fig. 03, fig.04): Align the car seat attachment with the
adapters and press down, a click will indicate the correct attachment of the car seat
to the pram frame complete with adapters. Pay attention that both sides are correctly
attached.
WARNING: Before use, always make sure that the accessory is correctly attached.
When lifting the car seat, upwards, it must not disengage from the pram frame.
Disassembling the REK car seat (fig. 05): Place the handle of the car seat in the
upright position by pressing the buttons on the side of the handle, see manual supplied
with the car seat.
• ENGLISH •
7