Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTION OF THE OUTDOOR SENSORS WITH THE WEATHER STATION
The outdoor sensors connect automatically after 1 minute. Otherwise, you can connect the devices
manually:
- When the weather station detects the sensors, the outdoor temperature will be displayed (24).
- The sensors data are sent automatically about every 3 minutes.
CHOICE OF SENSOR DISPLAY
To toggle between the data from the sensors:
- Use button (5) for selection (CH1 / CH2 / CH3).
2 - SETTING THE TIME AND DATE
- Press button (13) for 3 seconds to enter the time and date setting mode.
- Use buttons (9) and (10) to adjust the values. Hold the buttons down to speed up scrolling.
- Press button (13) to validate the selected digit.
- The day of the week is displayed automatically (18).
- If the buttons are not pressed, the unit returns to the normal display after 15 seconds.
3 - SETTING THE ALARM
SETTING AND ACTIVATING THE ALARM
- Press button (7) for 3 seconds. The symbol «AL1» appears on the screen.
- Use buttons (9) and (10) to set the alarm hour. Press button (7) to confirm. The minute digit
flashes.
- Select the alarm mode (Beep / Radio) using buttons (9) and (10).
appears on the screen.
appears on the screen.
The alarm will activate the last
station listened to.
- Proceed in the same way as for alarm 1.
- To select one of the two alarms, press button (7).
- The screen will display consecutively the symbols «AL1», «AL2» then the 2.
- Press button (7) again to deactivate the alarms (no symbol is displayed).
SWITCHING OFF THE ALARM
the next day at the same time.
SNOOZE FUNCTION
- When the alarm sounds, press SNOOZE (5): the symbol Z
- The alarm will sound again after 9 minutes.
- To cancel the snooze function, press button (7) or (13).
Z
Werbung
