Aquaglide REBOUND 20 Bedienungsanleitung Seite 7

Chart 1 – Working Pressure by Chamber - REBOUND 20
Valve [Inflate Order]
MAIN [1]
SWIMSTEP [1]
1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position will also make launching
easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note original folding & packaging
method. Remove valve cap and confirm valve is in inflate (1-way airflow) position.
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use pump to inflate Main Valve [1] to
Working Pressure as shown in Chart 1.
4. Repeat step 3 instructions to inflate the separate Swimstep boarding feature to proper Working Pressure shown in
Chart 1.
5. Confirm that suitable anchor(s) and mooring lines are in place before launching this item (see Anchoring).
6. To launch product, lift completely and place in water. Large items may require many extra people to accomplish this.
Never drag product as damage may occur.
7. When connecting multiple items together, always follow manufacturer's recommendations. Use only Aquaglide Two-
Step Vario-lock cinch straps and connecting rings. Make sure connection is tight and there is NO GAP between items.
Failure to connect items properly may result in injury or death. See E1 - E6.
a. Attach straps to 'Boarding Features' (example: SWIMSTEP, Splashmat, Speedway, Breezeway or Deck) where a
connection is required. Boarding Features should not be attached to other Boarding Features.
b. Use all available rings to make connection. Standard connections use 5 rings. Swimstep uses 3. REBOUND 20
is a BOUNCER with 5-ring connections on 4 sides. REBOUND 20 also has one set of Log Rings for optional I-Log
accessory, and one set of Slide Rings for optional Plunge Slide accessory.
c. Float 'Boarding Feature' into desired position. Note: a matching set of connecting rings is required on feature item.
Included SWIMSTEP boarding platform should attach to the CENTER 3 rings on the boarding side of the bouncer.
d. Attach center strap to center ring on feature item. Connect loosely, then work outward until all straps are
connected.
e. Dive beneath to tighten all straps securely. Dive mask and several attempts may be required.
7
Working Pressure in psi (Bar)
1.2psi (0,083 bar)
0.8psi (0,055 bar)
Connecting Strap instructions
E-1
E-4
E-2
E-5
E-3
E-6
www.aquaglide.com