ELNA Ladder 4 Anleitung Seite 9

Note: In connection with the constant work on improving the product, which increases its reliability and improves
operational indicators, changes may be made to the design, which are not reflected in this operating manual.
5 Security requirements
The towel warmer must be connected to an electrical network that has grounding. Before connecting the towel warmer
to the electrical network, make sure that the cord, plug and outlet are in good condition.
WARNING!!!
This appliance is intended only for drying/heating textiles. To eliminate danger for a very small child, the towel
warmer must be installed so that the lower heated side is located at a height of at least 600 mm from the floor level.
This product can be used by children aged 8 years and older, as well as by persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, who have been previously trained in how to use the
product safely, understand the hazards involved. The towel warmer in the bathroom must be installed so that a
person in the shower or bath cannot touch the switches and controls.
IT IS PROHIBITED:
5.1 Install the towel warmer at a distance of at least 0.6 m from the bathtub, water faucet, toilet, bidet, shower cabin or
box, hand wash basin, etc.
5.2 Install the towel warmer in rooms with a chemically active environment (this is a room with steam or deposits that
affect insulation, conductive parts of electrical equipment and other parts).
5.3 Simultaneously touch the turned on towel warmer or the wet textile product on it, and devices with natural
grounding (water taps, radiators and heating pipes, water heaters, washing machines).
5.4 Disassemble the towel warmer.
5.5 Operate the towel warmer if the electrical cord is damaged or the housing is depressurized.
5.6 Direct a continuous flow of water or water the towel warmer from the shower.
5.7 Carry the towel warmer by the power cord.
5.8 Repair the towel warmer by yourself.
5.9 Keep inflammable substances near the switched-on device.
5.10 Access to the towel warmer for children, in order to avoid skin burns.
5.11 Clean the towel warmer using abrasive materials and chemicals not intended for the care of stainless surfaces and
painted surfaces.
5.12 Apply force to the towel warmer capable of deforming or damaging its structure or connections.
5.13 Use the towel warmer for purposes other than drying wet towels, wet technical products and heating the room.
WARNING! The use of any cleaning fluids on towel rails in gold finishing is prohibited. Gold towel
warmers should only be wiped with a cotton napkin.
6 Preparation for installation
Unpack and remove the towel rail from the packaging, unpack the power cord.
6.1 OPEN CONNECTION
- Remove the plug from the towel rail and remove the connection wires (Fig. 1).
- Remove the protective falstons of the cable ends (Fig. 2).
- Connect the power wires with cable ends (Fig. 3).
- Connect the yellow-green wire with a terminal (Fig. 4).
- Hide the connection to the body of the towel dryer (Fig. 5).
- Fix the network cord in the cut-out of the outlet of the cords and close it with a plug (Fig. 6).
It consists of a welded steel body of one round rack and
several round bars with an electric heater element inside.
The temperature regulator is mounted on the rack.