ELNA Ladder 4 Anleitung Seite 8

- nieprzewidywalnych warunków pracy (katastrofy naturalne, pożar, czynniki zewnętrzne);
- braku lub wadliwej konserwacji, mechaniczne uszkodzenia, niedotrzymanie zasad eksploatacji, transportu, wpływ
elementów chemicznych, nieprawidłowe działanie domowej sieci elektrycznej (wbrew obowiązujących przepisów
państwowych).
1 General instructions
1.1 Heating electric towel warmer is designed for drying towels and other textile products and is installed in residential,
domestic and auxiliary premises with a power supply voltage of 230 V, frequency of 50 Hz.
1.2 Limit deviations of consumed power from the nominal should not be more than +10%, less than -10%.
Before starting operation, read this manual carefully and follow its recommendations. When you are buying a towel
warmer, ask the seller to check its completeness, serviceability and performance in your presence. Make sure you have
the date of sale, the seller's signature and his stamp in the "Certificate of Acceptance and Sale" section.
In the design of the electric towel warmer, cold zones are allowed in the places where the power cord is connected up
to 10 centimeters.
On the vertically located parts of the towel warmer, a decrease in temperature is allowed, which is connected with the
constructive placement of the heating element.
2 Specifications
2.1 Nominal supply voltage, V
2.2 Type of current - alternating, Hz
2.3 The mode of operation is long
2.4 Warm-up time to steady state, min., no more than
2.5 Protection against solid particles and low velocity sprays of water
2.6 The temperature of the outer surface of the towel warmer,
at an ambient temperature of 20°C, no more than
2.7 Permissible load on the towel warmer, no more than – 5 kg
2.8 The material of the case is stainless steel
2.9 The type of thermostat is a built-in timer-regulator (Dimmer)
When the voltage changes and/or the ambient temperature changes, the surface temperature of the product will
change. When covering the dryer with a towel or other textile product, the temperature of the dryer may rise to 15°C
at
the place of the covering, which is not a malfunction.
3 Complete set
3.1 Towel warmer – 1 pc.
3.2 Connection cord – 1 pc.
3.3 Mounting set – 1 set.
3.3 End cap – 2 pcs.
3.4 Rubber sleeve – 1 pc.
3.6 Quick-coupler – 4 pcs.
3.7 Operating manual – 1 pc.
3.8 Package – 1 set.
4 The construction of the warmer
Design of the towel warmer according to its model is indicated in Table 1.
Anastasia, Atria, Ladder, Ladder Lux, Ladder Elite, Cascade,
Cascade Lux, Cascade with Shelf, Cascade Lux with Shelf,
Katerina, Sicilia, Standard, Standard Lux, Trapezium
Vertical, Fluger
– 230
– 50
Model
ENG
– 10
– IP 44
– 65°C
Design of the towel warmer
It consists of a welded steel body of two square or round
racks and several square or round bars with an electric
heater element inside. The temperature regulator is
mounted on the rack.
Table 1