Phottix Odin TTL Benutzerhandbuch Seite 9

TTL / M / O
While groups A, B or C are selected, pressing
the Mode button will change from TTL, (M)
Manual, or O functions.
TTL:
Will re ashes using TTL metering. The
EV level of each group can be adjusted up or
down (see above).
M:
Flashes are set in Manual mode and power
levels adjusted up or down (see above).
O :
Selecting O (signi ed by three
underscores _ _ _) will turn o the selected
group and not re any remote ashes in that
group.
Fast Exit
Pressing the TCU Power Button after making
changes to settings will exit edit mode. The
TCU will save the current settings.
En
Ratio Functions Screen
The Selection Button allows you to cycle
through A:B ratio adjustments, EV adjustments
and Channel selections.
Press the Selection button to access Ratio
adjustments. Press the + / - button until the
desired A:B ratio is achieved.
Pressing the Selection button again will move
the active selection to the EV adjustment
section. Press the + / - button until the desired
EV level is achieved.
The Selection Button can also be used to
navigate to the Channel icon. The - / + buttons
will change the transmission channel (1, 2, 3 or
4) when Channel is selected. This will change
the channel the TCU uses to transmit.
INSTRUCTION MANUAL
9