Carson X-Base 2.0 se Betriebsanleitung Seite 12

PB BATTERY PROGRAM
This is programmed for charging Pb batteries with a nominal
voltage from 2 to 20 V. Pb batteries cannot be charged rapidly.
They can only deliver relatively lower current compared to their
capacity.
The optimal charge current will be 1 /10 of the capacity. Please
always follow the instruction supplied by the manufacturer of the
battery.
When you are willing to alter the parameter value in the program,
press „Enter" key to make it blink, then change the value with the
"INC/DEC" keys. The value will be stored by pressing the "Enter"
key once. Then press the "Enter" key for more than 2 seconds to
start the process.
This shows the number of cells you set up and the processor
detects. "R" shows the number of cells found by the charger and
„S" is the number of cells selected by you at the previous menu. If
both numbers are identical you can start charging by pressing the
"Start/Enter" button. If the numbers are not identical, press the
"Mode/Esc" button to go back to the previous menu. Then care-
WARNING AND ERROR MESSAGES
GB // 12
The output is connected to a battery with incorrect polarity.
This will be displayed in case of detecting an interruption of the connection between the battery
and the output, or voluntarily disconnection of the charge lead during the operation of charge or
discharge.
There was a shortcircuit at output. Please check the charging leads.
The voltage of input power drops out of the limit.
The processor detects the voltage is lower than you set at the Lithium program. Please check the cell
count of the battery pack.
The voltage of one of the cells in the lithium battery pack is too low. Please check the voltage of the
cell one by one.
The processor detects the voltage is higher than you set at the Lithium program. Please check the cell
count of the battery pack.
The voltage of one of the cells in the Lithium battery pack is too high. Please check the voltage of the
cells one by one.
In the process of charging, the battery connection breaked off.
In balance charge mode, the balance port connection breaked off.
fully check the number of cells of the battery pack to charge again.
This shows the present situation during charge process. To stop
the charging press the "Mode/Esc" key once.