3.5 Smart Extra Battery
This RI 500 can use ALLPOWERS
superposition
of 2 battery packs at most.
When using this product for extra battery connection, please connect it according to the specifications of
the user
manual.
Please note that in the connection state, the rated maximum output power does not change, only the
battery capacity is superimposed
Please use the connection
Users can connect the power station capacity as shown in the figure below.
WERS
3.6 UPS function
This product supports UPS (Uninterruptible
AC input port of this product through the AC charging cable, and the electrical appliance can use the AC
output port of this product to work (at this time, the AC power comes from the power grid, not the battery).
When After the power grid is suddenly cut off, this product can automatically
supply mode of this product within 15ms. It is recommended
not use multiple devices at the same time to avoid overload protection of this product. If the power station
fails to operate normally or data is lost if the operation is not in accordance with the instructions, our
company does not assume the corresponding
Note: 1.When AC charging and AC output active, the UPS function icon automatically lights up to activate
the
UPS
function
2. To ensure the UPS works, the maximum power of the AC output ports should not exceed 1500W when
the mains voltage range is 100-120V, Otherwise, the power station will supply power to the devices until
the power station consumes to 5% of the power and turns off the AC output.the maximum power of the
AC output ports should not exceed 1800W, when the mains voltage range is 220—240V.
Smart Extra Battery for capacity expansion, and can support the
cable provided by our company for connecting to avoid damage to the product.
(uninterruptible
power
Power Supply) function. You connect the power grid and the
o
o
e
o
supply)
to use only one device during use, and do
responsibility.
(8)
R1500+Extra Battery
switch to the battery power