Storage And Transportation; Disposal And Recycling; Troubleshooting - Elinchrom ELB 1200 Gebrauchsanleitung

User Manual

STORAGE AND TRANSPORTATION

• To improve the lifetime and security of your battery, please shutdown the battery
for storage and transportation. The shutdown mode prevents self-discharge.
• To avoid progressive battery discharge (so called SELF-DISCHARGE*) which can
EN
cause a DEEP DICHARGE MODE**, please do not store fully charged battery packs
for more than 6 months without use. If you have several batteries please use them
all or alternate amongst them.
• Please refer to our separate TRAVELLING BY AIR AS A PASSENGER Instructions
(73042, orange leaflet) for current transportation regulations.
*SELF-DISCHARGE MODE
Small losses of charge are observed during storage of a charged battery (self-discharge), which is a natural
process. These losses are more important while the BMS (Battery Management System) is ON. Turning the
battery pack OFF can help to reduce battery self-discharge by up to 100 times.
To limit the self-discharge losses, please shut your battery down for transportation and storage.
**DEEP DISCHARGE MODE
If the battery is not recharged over a long period of time (several months or more), the self-discharge process
may progressively cause the battery to enter a state of DEEP DISCHARGE.

DISPOSAL AND RECYCLING

This device has been manufactured to the highest standards from materials, which
can be recycled or disposed of in a manner that is not environmentally damaging.
The device may be taken back after use to be recycled, provided that it is returned in
a condition that is the result of normal use. Any components not reclaimable will be
disposed of in an environmentally acceptable manner. If you have any question on
disposal, please contact your local office or your local ELINCHROM Agent (please visit
our website for a list of all ELINCHROM agents worldwide).

TROUBLESHOOTING

The ELB 1200 Battery is equipped with a Smart Protection System allowing it to
disconnect automatically to prevent damage to the Li-Ion cells. If the fault cause is
removed,
the battery will return to the normal mode automatically.
The 4 LEDs will indicate the corresponding fault (please refer to the table below).
PLEASE CONTACT YOUR DISTRIBUTOR if it's impossible to recover from the fault or
the battery is often entering a fault mode.
8