eta SKYFRY Bedienungsanleitung Seite 25

Description - control panel and display
This is a touch control panel. Therefore, no pressure needs to be applied to touch the buttons
(symbols) displayed. During operation, the progress of the current time and temperature can be
monitored on the display. A selected programme can be ended at any time by pressing the B1 button.
Button
ON/OFFbutton – after pushing the button in the stand-by regime, the deep
fryer is switched on, after repeated pushing the deep fryer will stop or active
programme will switched off.
MODE button – after pushing, one of the pre-defined 12 programmes is set.
ON/OFF/PAUSE button – after pushing the button the set function is
activated; after pushing during the operation, the running function is
interrupted.
Temperature increase / decrease buttons – after short pushing, the
temperature is increased / decreased by 5 °C, after long pushing, the
increase / decrease speeds up,
Time increase / decrease buttons – after short pushing, the time is
increased / decreased by 1 min., after long pushing, the increase / decrease
speeds up.
Scope of temperature setting 80 – 200 °C and time 1 – 60 min.
Auto Stand-By after < 20 min. selected operation is not confirmed by pressing the button.
Sound and light signalling will be activated:
– When the power supply is connected to the electrical supply (1x sound signal),
– When the button is pressed (1x sound signal).
– When the set program ons (1x sound signal).
– When the food is to be shaken / stirred (5x sound signal + ((SHAKE)).
– When the set program ends (5x sound signal + End).
– When the container is inserted into the fryer body after an interruption in operation
(1xsound signal).
• If unusual characters appear on the display, disconnect the appliance from the power
supply and then reconnect it.
Frying
Place the assembled fryer on a flat surface (e.g. kitchen table) at the height of at least 85
cm, out of reach of children. Fill the container with the desired ingredients (NEVER fill any
frying pot more than MAX mark) and assemble the whole fryer properly. Connect the plug
of the A7 power cable to the mains. All symbols light up shortly. They subsequently fade
away and only the B1 button symbol remains lighted up. By pushing button B1, the pre-
set temperature of 180 °C lights up on the display and it alternatively changes at pre-set
times of 15 minutes (programm the Hot air).
Function
Caution
EN - 25
EN