Operation On The App; Control Interface; Choose Mode; Manual Mode - Emke Rth2W Bedienungsanleitung

05

OPERATION ON THE APP

5.1 Control interface

ON/OFF
Adjust temperature

Choose mode

5.2 Choose mode
Tap the mode button on the interface to choose Manual, ECO and Auto mode.

5.2.1 Manual mode

In manual and Eco mode, simply use the sliding dial or the

5.2.2 Eco mode

In manual and Eco mode, simply use the sliding dial or the
5.2.3 Auto mode
In Auto mode, you can use presetting program to work the device, the default program can be found by end of the manual.
If you hope to amend the program, it can be editable on the interface "Program "

5.3 Program Data

Tap the "Program" on the control interface to configure a program. The program consists of 4 different periods intervals
for each day.
Option 1: You can follow the default program setting without any operation.
Option 2: You can modify the default setting to your preferred program setting following the instruction on the interface
for different period.
11
Program
Setting
Room temperature
Adjust temperature
and to adjust the set temperature.
and to adjust the set temperature.

5.4 Device setting

Tap the icon to view and adjust the thermostat's settings. This menu allows you to configure several settings not
available through the control dial.
From Setting, you can set below operation:

5.4.1 Open valve

The value obtained by running the internal program of the device, not require any operation by the user.

5.4.2 Child Lock

Use the toggle switch to lock or unlock the thermostat display. "L" displays on the screen when the device is locked.

5.4.3 Open Window Detection

This function enables the automatic detection of an open window when the thermostat is working. Use the toggle switch
to active open window detection function or not (The default set is off).
If the thermostat detects a sudden drop in temperature (2°C or more within 5 minutes), the OP icon will appear on the
TRV screen,meanwhile APP will appear the
wastage as heat escapes through the window.
It will automatically revert back to the previous mode continue to heating after 30 minutes,the OP icon will disappear
on the TRV screen. If the temperature drops by 2°C within 5 minutes again, the thermostat will continue to stop
heating, then cycle through.

5.4.4 Frost protection

In turn off state,the device will automatically working when it detect the temperature is lower than setting once the frost
protection is switch on.the setting rang is 5-15°C(Defaulty 5°C).

5.4.5 Temperature Calibration

The temperature compensation setting allows users to adjust for any discrepancy between the average room temperature
and the temperature sensed by the thermostat,For instance, if the temperature in the room is 18°C, but the radiator is
sensing 16°C, a compensation factor of +2°C will offset the difference. Press the
is from - 8~8°C in steps of 0.5°C (The default set is 0°C).

5.4.6 MPI Enable

Turn on MPI mode, the corresponding KP KI value will be turn on. the value are obtained after laboratory testing for
improve the comfort of heating spaces, It is not recommended to revise the value.
Or Turn off MPI mode , the corresponding KP KI value will be turned off. just like the normal valve switch function, no
other special smart function.
5.4.7 Kp value
It is not recommended to revise the KP value.
5.4.8 Ki value
It is not recommended to revise the KI value.
5.4.9 Historical Temp Review
The device operation history, not require any operation by the user.
A Open valve
B Child Lock
C Open Window Detection
D Frost protection
E Temperature Calibration
F MPI Enable
G

Kp valve

H

Ki valve

I

Historical Temp.Review

icon,the device will stop heating for 30 minutes to prevent energy
or to adjust. The setting range
12