Initialization And Calibration On The Radiator Thermostat; Connecting To Wifi; Downloading The App; Add Gateway - Emke Rth2W Bedienungsanleitung

2.1.2 Press the U position to remove the battery cover as shown in the diagram, insert two AA batteries (ensure the
correct polarity) and mount the cover back to the thermostat correctly.
2.1.3 Before mounting the thermostat to valve, ensure the thermostat is on open position (the plastic plunger of the
thermostat is in open position). Thread the nut of thermostat to the valve tightly.
If your valves listed as below, please refer to the following picture
for the adaptor installation first.

2.2 Initialization and Calibration on the radiator thermostat

2.2.1 Once the batteries installed, the TRV will display ---, press icon
flashing, you can mount the thermostat to the valve now (Ensure the plastic plunger in the thermostat is in open
position before you mount the thermostat to the valve)
2.2.2 PAfter mounting the thermostat to the valve, press icon
starts automatically.
2.2.3 Once calibration is done, the display will be automatically on (you can touch the display to active it if it is dark),
now you can operate the thermostat.
03

CONNECTING TO WIFI

3.1 Downloading the App

Download the APP onto your smart phone. You can find the app by scanning the QR code below or searching "INOW"
in the Google Play or Apple app store. Install and follow the app's instructions to create an account.
07
on the display for initialization, the display start
, the display becomes dark, simultaneously, calibration

3.2 Add gateway

When the phone is connected to Wi-Fi, open the APP and add the gateway by following. (Ensure Indicator fast flashing ,
if not will need to reset the device according to the instructions at the end of the manual before you add it .)

3.3 Wifi signal pairing between smart radiator thermostat and gateway

Note: Before pairing radiator thermostat to the APP, please make sure the gateway has been connected to the APP
08