Manual Mode; Eco Mode; Automatic Mode; Manual Operation On Smart Radiator Thermostat - Emke Rth2W Bedienungsanleitung

1 Find and Click "gateway" on APPClick "Add subdevice".
5
When icon on the display stop flashing, means code
pairing is done and thermostat will be shown on the APP
screen as below pictures, you can also edit the product
name on the APP.
Note
When operating on the APP, TRV will have a delay of 3-5 seconds. This is a normal phenomenon.
because operateing the command on the APP , it will be transmitted to the GATEWAY , then
gateway passed to the thermostat, thermostat will execute the command after receive the
command. after the command is executed, it will be transmitted to the gateway, and gateway
will transmit it to the APP again.
09
2 3
Touch the display to active Hold and press icon
the buttons, press icon on Until icon is shown on the
the display to turn off thermostat display.
to dark display.
4
Press icon or on the
diaplay, icon start flashing.
After the interface is shown as below, you can operate the
preferred setting on the APP now
Repeat above operation, 16 radiator thermostats can be paired
with one gateway, ensure the WIFI signal is not weak for all the
smart radiator thermostats.
04
MANUAL OPERATION ON SMART
RADIATOR THERMOSTAT
To simply the operation on thermostat, it will just allow to manually control the temperature on the
thermostat by three modes by tapping icon

Automatic mode.

4.1 Manual mode

Press the button to enter the manual mode.
Set temperature can be adjusted by using the
hold the button to speed up.
Once the desired temperature setting under manual mode is completed, in few seconds, it will automatically show
the current room temperature and current mode on the display.
Symbol will be displayed when heating and disappear when it is not heating.

4.2 ECO mode

Press the button to enter the Eco mode. The default set temp is 17 °C.
Set temperature can be adjusted by using the
hold the button to speed up.
Once the desired temperature setting under Eco mode is completed, in few seconds, it will automatically show the
current room temperature and current mode on the display.
Symbol will be displayed when heating and disappear when it is not heating.
4.3 Automatic mode
Press the button to enter the Automatic mode.
Under the automatic mode, the icon will be displayed on the screen, and the STRV is running under automatic
mode by default temperature even the temperature on the display can be regulated (you can read the default
temperature chart of automatic mode by end of the manual).
Once automatic mode is chosen, in few seconds, it will automatically show the current room temperature and
current mode on the display.
to switch between modes: Manual mode, Eco mode,
and buttons. The range is 5-35 °C in steps of 0.5 °C. Press and
and buttons. The range is 5-35 °C in steps of 0.5 °C. Press and
10