Hama TH-140 Bedienungsanleitung Seite 5

Warning - batteries / button cells
• Do not mix old and new batteries, or batteries of different types or from
different manufacturers.
• Remove the batteries from products that are not being used for an extended
period (unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow them to enter the
environment. They can contain toxic, environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of them without delay.
• Avoid storing, charging and using in extreme temperatures and at extremely
low atmospheric pressures (such as at high altitudes).
• Ensure that batteries with damaged housings do not come into contact
with water.
• Keep batteries out of the reach of children.
• Do not swallow batteries or button cells. Burning hazard from hazardous
substances.
• If the battery compartment will no longer close securely, stop using the
product and keep it away from children.
• This product contains button cells. If the button cell is swallowed, serious
internal burns can occur within 2 hours and ultimately lead
to death.
• If you suspect that a button cell has been swallowed or is in
any part of the body, seek medical attention immediately.
• Keep new and used button cells out of the reach of children.
4. Getting started
Open the battery compartment cover (6), remove the contact breaker and then
close the battery compartment cover (6). The thermometer is now ready for use.
4.1 Base (7)
To stand the product, the base (7) must be pulled out beneath the battery
compartment cover (6) and folded over.
5. Operation
5.1 Setting the date/time/time format
• After removal of the batteries' contact breaker, the normal time is displayed in
12-hour format and a melody signals that the product is ready for use. (Normal
time mode)
• Press the UP (4) or DOWN button (5) to switch between the 12 and 24-hour
formats.
• Use the UP button (4) or DOWN button (5) to select the desired format.
• Then press the SET button (3) to make the following settings:
• Hours
• Minutes
• To select individual values (hours/minutes), press the UP button (4) or the DOWN
button (5) and con rm each selection by pressing the SET button (3).
• Then complete the process using the MODE button (2).
• To change the set time, you must press the SET button (3) for 2 seconds; you can
then continue as described above.
• Pressing the MODE button (2) twice takes you to the date/year/month settings. To
enter the values, hold the SET button for approximately 3 seconds.
3