while assembling the product.
• Keep the packaging and user manual as they contain important information.
• Prior to first use, remove all fasteners and packaging material and store them out of the reach of
children to avoid the risk of suffocation.
SAFE USE OF BATTERIES:
• It is recommended that the batteries should be inserted, removed and replaced by an adult.
• Do not mix different types of batteries or new and used batteries.
• Do not mix alkaline, standard (carbon-zinc) and rechargeable batteries at the same time.
• Do not recharge non-rechargeable batteries.
• Batteries intended for charging should be removed from the product before charging.
• Batteries must be inserted with the correct polarity (+ and -).
• Insert the batteries according to instruction.
• Exhausted batteries should be removed from the product.
• Do not throw the batteries into fire.
• Turn off the product before inserting batteries.
• Do not short-circuit the battery terminals.
• Keep batteries away from children.
• Protect against contact with water.
COMPONENTS:
1. Backrest frame
2. Rear connector tube
3. Right support frame
4. Music box
5. M3*13mm Screw
To assemble the product you will need a phillips screwdriver (not included in set).
PRODUCT ASSEMBLY:
1. Place the left and right support frames opposite each other, with the rear connector tube between
them (1).
2. Lift the flip clip on the both side of the rear connector tube, fit the left support frame and right
support frame into the rear frame tube. Close the flip clip over the tube and push down until the flip
clip locks in place (2,3).
3. Fit both ends of the footrest frame and screw down (4,5).
4. Fit both ends of the backrest frame by holding down the spring loaded pin and push the frames till
the pin locates into the holes (6).
5. Open the pocket at the rear of the seat cover back and slide over the seat backrest,stretch the
bottom of the seat cover over the footrest frame (7).
6. Slide the top of the music box through the hole in the seat cover and onto the footrest frame. Attach
the clips under the seat (8,9).(Notice the orientation of the music box)
7. Clip the toy bar to each side of the bouncer frame (10). Pull the clip off to remove the toy bar.
EN
6. Footrest frame
7. Left support frame
8. Seat pad
9. Toy bar and toys
7