Operation - Matrix X One Bedienungsanleitung

table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
• voltage at the power socket
• whether there is good contact at the charging
contacts of the charging unit.
If the battery pack still fails to charge, send
• the charger and charging adapter
• and the battery pack
to our customer service center.

6. Operation

6.1 To change over between mains-powered
and battery-powered operation, press the
selector switch (10):
• To change over between compressed air and
low-pressure operation, press the selector
switch (10):
• Switch to the left: Compressed air operation
• Switch in the middle: OFF
• Switch to the right: Low-pressure operation
6.2 Compressor compressed air operation
• To inflate objects with compressed air, use
the compressed air hose (2).
• Connect the adapter of the compressed air
hose to the object you wish to inflate.
• Depending on what you are inflating, also use
the adapters (6, 7, 8) or other adapters available
from retail stores.
• The pressure at the compressed air hose will
be displayed in the display (9).
• The unit of the displayed pressure can be
selected with the button (13). The pressure can
be displayed in units of [bar], [PSI] or [kPa].
• The button (12) allows the desired pressure
to be reduced.
• The button (14) allows the desired pressure
to be increased.
• Switch on the equipment by moving the
selector switch (10) to the compressed air
operation position .
• The compressor will then pump until the preset
pressure on the display is reached, then it will
switch off.
• Warning! Observe the information supplied
by the tire manufacturer and the vehicle
manufacturer relating to the recommended tire
pressure.
• Warning! This equipment is not calibrated!
For a calibrated measurement value, check
the actual tire pressure using a calibrated meter
after you have inflated the tires yourself, e.g. at a
petrol station.
• Just before it is switched off, the pressure which
is shown in the display can be 0.05 – 0.2 bar
higher than the preselected pressure,
because of overpressure in the air hose.
• Allow the compressor to cool down for about
5 minutes after every 5 minutes of operation
in order to prevent overheating.
6.3 Low-pressure blower operation
6.3.1 Suctioning air
• To suction out objects with a large volume
until they are empty (e.g. deflating an air
mattress, etc.), connect the air hose (2) to the
extractor connection (3).
• Connect the air hose to the object you wish
to deflate.
• Switch on the equipment by moving the
selector
switch (10) to the low-pressure operation
position.
• Switch off the equipment once the object has
been sufficiently deflated.
6.3.2 Infl ating
Warning! When using the equipment to inflate
objects, check the information and safety
instructions provided by the manufacturer.
• To inflate objects with a large volume (e.g.
inflating an air mattress, etc.), connect the air
hose (2) to the inflating connection (11).
• Connect the air hose to the object you wish
to inflate.
• Switch on the equipment by moving the
selector
switch (10) to the low-pressure operation
position .
• Switch off the equipment once the object has
been sufficiently inflated.
UK
13