Manual Operation - Dms Ihs-2500 Bedienungsanleitung

- P2 - P3 - P0" appears on the digital tube as a circulation , corresponding to the appliance mode
is "Stand-by ---Low-grade---Mid-grade---High-grade---Stand-by".
3. In stand by mode, press the timer button, the appliance can set time from 1 to 24 hours. After
set the time, the indicator next to the digital tube will light up, it means that the appliance has
been selected timer function. "0" indicates time not set.
4. When the appliance is on working, the digital screen always shows the power state (P1-P2-
P3). The timer setting, when the indicator lights up, it means that the machine has been set a
timer function from 1 to 24 hours. To view the regular time, press the timer button, the appearing
time is the present setting time, at this time the indicator also flashes three times continuously,
indicating that the appliance enters into the timer setting state.

7.3 Manual Operation

Control through the main module on the heater:
P0 indicator appears on the screen when the heater is switched on and it is in stand by mode.
st
The 1 digit on the screen illustrates P symbol while 2
to 3.
The button number 1 on the heater functions as ON / OFF. The heater starts operating at the
power level mode at which it has been switched off.
Press the button number Temi on the heater to adjust power mode.
P0 appears on the screen when pressed ON / OFF button and the power level mode
(P1，P2，P3) can be adjusted through the buttons on the remote control.
Press ON / OFF button on the remote control or the heater itself to switch off the heater.
The heater starts functioning in stand by mode after electricity cut.
LED keeps flashing in case of a program set by remote control.
Buzzer signal is given following each command.
LED
Power level indicator
P
nd
digit illustrates power level mode from 1