DMS IHS-2500 Bedienungsanleitung Seite 16

There are 4 brackets and fasteners used with the heater. Furthermore, in the canal of
1.
back side of the heater there are 4 square fastener washers 25×25mm. Relieve square
washers(Figure 7.1)and fasten 2 brackets to the canal of the backside of the heater by
the help of screws(Figure 7.2.)
Fasten the brackets at the appropriate distance of each other(45-55cm)
2.
(Figure 8).
Two other brackets are fastened by the help of fasteners at the appropriate distance
3.
on the wall parallel to the floor (At least 1.8 m from the floor and at least 0.5 m from
the ceiling).(Figure 5).
Join the brackets on the heater with the brackets, fastened on the wall, with help of
4.
figured screw-nuts(Figure 6).Install the heater under necessary angle (in the direction to
the area being heated).Look at issue 4:(Main rules of heater using).