Appliance Installation - Cecotec Proclean 2010 Inverter Bedienungsanleitung

3. APPLIANCE INSTALLATION

Turntable installation (Fig. 2)
The turntable installation, with shaft and ring assembly, requires several steps.
1. First, the ring assembly must be positioned on the base of the microwave, making sure
that it is correctly aligned and locked into place.
2. Then, the shaft must be placed at the centre of the ring assembly, checking that it is
securely fastened and that it can rotate freely.
3. Once the ring assembly and shaft are in position, the bottom part of the turntable is placed
on the shaft, making sure that it fits snugly against the shaft and can rotate smoothly.
NOTE: It is important to check that the turntable is levelled and centred for an optimal
microwave operation.
4. Once everything is in place, you can switch on the microwave and use the turntable as
needed.
Fig. 2 key
1. Turntable
2. Bottom part of the turntable
3. Shaft
4. Ring assembly
NOTES:
- Never place the turntable upside down. The rotary motion of the turntable must never be
blocked.
- The turntable, shaft and ring assembly must always be installed before starting the
microwave.
- Food and containers must always be placed on the glass turntable.
- If the glass turntable or the turntable ring assembly cracks or breaks, please contact the
official Cecotec Technical Support Service.
Worktop installation
1. Remove all packing material and accessories.
2. Check the microwave to see if it is damaged.
NOTE: Do not install the microwave if it is damaged.
3. Remove any protective film from the surface of the microwave.
NOTE: Do not remove the mica plate protecting the magnetron inside the microwave cavity.
Installation instructions and specifications
Fig. 3
1. Place the microwave on a level surface. Make sure that there is nothing obstructing the
PROCLEAN 2010 INVERTER / WHITE
ENGLISH
59