DMS SH-2000 Bedienungsanleitung Seite 16

STEP 2: Insert 4x universal rawl plugs (B) into the drilled holes. Insert 4x screws (A) into rawl plugs leaving
heads proud.
STEP 3: Hang the bracket onto the 4 screws in the wall.
BEFORE THE FIRST USE
• Remove all packaging of the device.
• Check if the voltage of the appliance corresponds to the main voltage of your home. Rated
voltage : AC220-240V 50Hz
• Place the base on a flat surface and unscrew the screws.
• Place the rod with the flange on the base, Tighten it with screws.
• Place the plastic cover over the connection of the foot and the rod.
• Place the other two rods on the first rod and tighten these with the screws, make sure the
rod with the plastic collar is mounted at the top.
• Mount the heater on the thin rod and tighten the screw.
• Guide the cable along the rod through the 2 cable guidance clips downwards. The device is
ready for use.
• If the heater is placed on a wall, the rods and the foot are not necessary.
• Mount the supplied bracket to a solid straight wall.
• Attach the heater to the holder. Keep at least 50 cm free space around the device.
• Place the heater at least 180 cm above the ground.
USE
• Always plug the device into a grounded outlet.
• Place the device in a place with at least 50 cm free space around the unit.
• In case of rain or bad weather never use the device, unplug directly from the outlet and store
the appliance in a dry place.
• Make sure that children, people with mental disabilities and pets never come close to the
heater. Never touch the heater, it is very hot, you can get very seriously injured!
• Important: Please make sure that the device is installed 100% level. If the device is not level,
it will not heat up! This is a safety precaution to prevent the device heating up when it tips
over.
• Pull the switch cord to set the desired heating mode.
• The following table lists the different heat settings. For another position pull the cord.
• To switch off the device pull the cord several times until the symbol 0 appears.