Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Wall mounted function
Product overview
Installation
Prior to assembly; read the instructions carefully. Check all parts against the Product Overview.
This product must not be used if the power cable is damaged. If there is damage, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
For ease of assembly only loosely tighten bolts and then tighten fully when assembly is complete.
WARNING-Do not over tighten bolts; only tighten with moderate pressure to avoid damaging the bolts or
components of the heater.
STEP 1: Drill 4 holes into a suitably strong exterior wall by positioning the wall bracket (3) a minimum of 2m
above the ground and then mark the hole positions using a pencil; ensure the holes are straight by using a spirit
level (not included). Using a drill (not included), bore the holes in the positions you have just marked.
Werbung
