Product Installation; Maintenance - Key Automation Icon Ico10130 Anleitungen Und Hinweise Zu Installation Und Einsatz

EN

4 - PRODUCT INSTALLATION

Before starting
tion procedure, ensure that the
power supply is disconnected.
Connect the spotlight to the back-
bone wiring, ensuring the correct
polarity (fig. 2). Make sure that
the silicone
is correctly positioned betwe-
en the outer edge of the spot-
light and the installation surface.
Widen the retaining springs by rota-
ting them 180° towards the back of
the spotlight, then insert the spotlight
into the previously prepared square
hole (fig. 5).

5 - MAINTENANCE

The spotlight does not require any
periodic maintenance. The integra-
ted LED module in this lighting fixture
is not replaceable. In case of failu-
re, proceed with the replacement of
the entire spotlight. To remove it from
the installation site, pull it perpendi-
cularly to the housing for about 3 cm,
then press and hold the springs
to prevent them from snapping and
hitting the spotlight's edge forcefully,
which could damage it (fig. 6).
WARNING !
It is advised not to lever the edge of
the spotlight (e.g., with a screwdri-
ver) and not to tilt it during remo-
val to avoid damaging the edges.
8
the installa-
perimeter gasket
Fig. 5
Fig. 6