Basic Operations - Soundmaster Srr80Ti Bedienungsanleitung

CONTENT OF DELIVERY
Main unit
➢
Instruction Manual
➢
POWER SUPPLY
➢ Ensure that the voltage is the same as that indicated on the identification plate on the main
unit.
➢ Connect the supplied power cable to a properly installed safety power socket and the plug of
the cable into the AC IN socket at the back side of the unit.
BATTERY OPERATION
1. Open the lid of the battery compartment at the back of the unit.
2. Insert 4 batteries of type UM-1 ("D" size) 1.5 V. Please ensure that the polarity is correct (see
indicated in the battery compartment).
3. Then close the battery lid.
Note:
➢ When the unit is powered by batteries, in order to play longer time, it is better not
to adjust the volume to max.
➢ If the device is operated with batteries and is in standby mode, the batteries will still be
discharged. To avoid this, we recommend removing the batteries or connecting the device
to the mains.
ERP power management
The device automatically switches to standby after 10 minutes if there is no audio
signal. For further use turn it on again.
POWER ON / OFF
To switch the unit on press "STANDBY/FUN".
To switch unit off press and hold "STANDBY/FUN".
SOURCE SELECTION
When unit is switched on, press repeatedly "STANDBY/FUN" to toggle between the sources:
DAB  FM  BLUETOOTH  USB  SD  TAPE
ADJUSTING VOLUME
Press repeatedly "VOLUME -/+" to decrease/increase the volume.
INSTALLATION
➢ Power Cable

BASIC OPERATIONS

2
SRR80 / English Instruction Manual