Connections; Connecting The Wireless Subwoofer - Samsung HT-E8200 Bedienungsanleitung

Connections

This section involves various methods of connecting the product to other external components.
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.

Connecting the Wireless Subwoofer

The Subwoofer's linking ID is preset at the factory and the main unit and sub should link (connect wirelessly)
automatically when turned on. If the link indicator does not light when main unit and subwoofer are turned on,
please set the ID by following the process below.
1 . Plug the power cords of the main unit and subwoofer into the AC power supply.
2 . Press the ID SET button on the back of the subwoofer with a small, pointed object for 3 seconds.
• The STANDBY indicator is turned off and the LINK indicator (blue LED) blinks quickly.
3 . In stand-by mode while the main unit is off, press the 0, 1, 3, 5 buttons in order.
• The red standby LED on main unit flashes and then stop in few second.
4 . Press the POWER button to turn on the main unit.
• The main unit and the subwoofer are now linked (connected).
• The Link indicator (blue LED) on the subwoofer is turned on.
| NOTE |
\ Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
\ If the main unit is powered off, the wireless subwoofer will be in the standby mode and the STANDBY LED on the upper side will blink.
\ If the main unit doesn't make wireless connection, follow steps 1-4 above to retry the connection between the main unit and wireless
subwoofer.
| CAUTION |
\ The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.
\ For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.
HT-E8200_XU_0315.indd 15 HT-E8200_XU_0315.indd 15
I D S E T
I D S E T
<The rear of the Subwoofer> <The top of the Subwoofer>
15
|
English
2012-03-15 오후 1:10:30 2012-03-15 오후 1:10:30