Next Level Racing HF8 Pro Bedienungsanleitung Seite 12

NOTICE
Sound Capture Mode Setup
Connect the 3.5mm audio cable that is included with the HF8 PRO to a Headphone Jack
1.
on your device.
Connect your Headphones/Headset to the 3.5mm input on the HF8 PRO.
2.
Make sure a blinking Green, Yellow or Red LED is showing on the HF8 PRO hand
3.
controller this indicates that the HF8 PRO is in Sound Capture Mode. (To change the
mode of the HF8 PRO, hold down the red button on the remote for 5 seconds).
PC Mode Setup
NOTE: To fully control the HF8 PRO from your PC, download the Next Level Racing HFS software
from the below:
refer to: https://nextlevelracing.com/support-downloads/
When the Next Level Racing HF8 PRO has a solid LED on the hand control, it is ready in PC mode.
As you adjust the Intensity knob the solid LED will change Green being the lowest intensity and
Red being the highest intensity.
1. Connect the USB connector to the computer's USB port.
2. The HF8 PRO requires software to connect to the games and use telemetry data to give
the best experience possible, we have provided free software called Next Level Racing
HFS which is available for download in the link below.
https://nextlevelracing.com/support-downloads/
HF8 PRO Mode Change
To change the feedback mode, hold down the red button on the remote for 5 seconds.
Result: The feedback mode changes to PC or Sound Capture.
NOTE: The LED indication will change to white when the button red NLR button is held and the LED
will flash the intensity color when in Sound Capture mode.
NOTICE
NOTE: (depending on your intensity setting) A blinking Green, Yellow or Red LED indicates that the
Sound Capture Mode is on.
Vibration Intensity Settings
Increase (Red LED light) or decreased (Green LED light) the vibration intensity by rotating the button
(located on the controller).
For questions, information, technical assistance or ordering user instructions, please contact our
team at hfs.support@nextlevelracing.com or support@nextlevelracing.com
12