Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Take care to position or set up the
product in an inaccessible place
when in use.
• Do not mount onto doors!
• Metal tips may not be used at all!
Preventing damage to the product!
• Use only appropriate replacement
tips, to prevent the darts from
ricocheting from the dartboard.
Long tips are not recommended
for electronic dartboards.
They bend or break easily (remov-
al of broken tips from the dart-
board – error messages).
• Do not expose the product to
adverse weather conditions or
extreme temperatures.
• Protect the product from wet and
moist conditions. The electronics
may be damaged.
Safety information for the
power adaptor
CAUTION!
Important information for the
use of the power adaptor!
Note: The equipment warms up
during normal operation.
• Only use the power adaptor for
Dartboard DS-5478/DS-5479.
• Use only original adaptor!
• Use only original replacement
parts in case of malfunctioning
parts!
• Unplug the power adaptor from
the mains power before discon-
necting the power adaptor from
the dartboard.
• The power adaptor is only suitable
for indoor use. Keep away from
moisture.
• Don't continue using the power
adaptor when the cover or supply
cable have been damaged.
• Disconnect the product from the
mains when not in use for an ex-
tended period.
• The output cable must not be
short-circuited.
• The outer connection cable of this
transformer cannot be replaced; if
the cable is damaged, the trans-
former should be disposed of.
Assembly instructions
Assembly of the dartboard
(Fig. B and C)
1. Select an appropriate location, with
approx. 3m free space.
2. The throw-off point is about 2.37m from
the dartboard. Mount the dartboard to the
wall in such a way that the mid-point of the
bullseye is around 1.73m from the ground.
3. Mark the relevant drill holes with a pencil,
using the drill template included. The mark-
ings "+" designate the dartboard's mount-
ing bracket. The markings "O" designate
openings on the dartboard, to facilitate the
long-term, stable wall-mounting.
4. Either mount the dartboard onto the
mounting bracket (13) (3 screws) or onto
the permanent wall mount (12) (4 screws).
GB
9
Werbung
