Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Prepare your camera for use
Lithium battery installa�on
Please install the lithium bat
1.
Slide the ba�ery cover below the camera to access the battery compartment:
Install lithium battery
2.
Insert the lithium ba�ery in the correct polarity direc�on.
3.
Then close the battery cover and slide it to lock it in place.
Note: Please remove the battery if you are not going to use the camera for a while.
Lithium battery charging
To recharge the lithium battery, simply connect the camera (without removing the battery) to your computer using the USB
cable provided in the box. The red LED on the back of the camera will light up to indicate that the battery is being charged, and
will turn off when fully charged. You can also charge the lithium battery by connecting the camera to AC power if you have an
adapter to which you can connect the USB cable.
SD memory card installation
This camera supports SD memory card up to 64 GB (not included). The internal memory can only store a few photos for test
purposes, these photos will be lost when you turn off your camera or remove away the battery. It is necessary to insert a SD
card into the camera before using it. Make sure that the SD card is inserted correctly by gently sliding i�nto the slot un�l it
clicks into place to confirm that it is locked. To remove the card, simply press it firmly and the card will ejectitself from the slot.
tery supplied with the camera before using it according to the following instruc�ons.
7
Werbung
