MS URBAN Betriebsanleitung Seite 21

To lift the backrest, hold it with your hand and shift it upwards. To lower the backrest to the recicling
position, lift the adjusting levers on both sides of the buggy and change the backrest position.
7. ADJUSTING OF HARNESS
Change of straps length in the harness by sliding the regulator to the one side or the other, adap-
ting it to the child's body.
8. ATTACHING THE FRONT WHEELS
Insert the front swivel wheel over the housing on the front leg. Be sure that the arrow on the swivel
lock is correctly orientated. Repeat for the other wheel (a). To fix the front wheels in the non swivel
position, turn the wheel so that the two notches on both housing line up at the front. Lift up te swi-
vel lock until it locks into place. To unlock, press down the swivel lock to release. (b).
9. ATTACHING THE RAINCOVER
The raincover simply drapes over your puschair with the hood extended. Fasten the press studs on
to the side of the hood and the velcro straps around the front legs to secure.
10. D-RINGS HARNESS ADJUSTMENT
To adjust the shoulder straps to fit your child correctly, use the pull shown in the image. Ensure the
harness is correctly fitted before useThe harness should be correctly adjusted in order to secure
your child at all times (a). To fasten de harness. Insert both fasteners securely into the clasp (b). To
release the harness, squeeze each side of the clip and pull away from the fastener, one at a time (c).
The D-Rings higlighted in red are provided for fitting a separate harness complying with BS 6684 (d).
21