Renegade RXS 100 Betriebsanleitung Seite 3

OPERATION GUIDE
POWER RATING
The RENEGADE RXS subwoofer enclosure are designed
for high bass levels. Anyhow it is possible, that unsatisfying
sound characteristics could be caused by too low or too
high amplifier power. In certain cricumstances this even can
cause a damage to the loudspeakers.
It is recommended to choose rather a more powerful
amplifier (ca. 15-20% more Watts RMS than the max.
RMS power rating of the woofer) and to use the amplifier
not at the maximum output level (low distortion factor, good
sound characteristics). A weaker amplifier at the maximum
level causes worse sound characteristics due to the higher
distortion factor.
Never crank up the output volume of your amplifier to the
maximum level or run the amplifier into the clipping range. If
the sound is distorted and not clean, turn back the level until
the distortions disappear.
Please observe the following recommended power ratings:
RXS1000
• One amplifier with an output power of approx. 160 up to
250 Watts RMS into 4 Ohms.
Please note that a lower impedance operation causes a
higher output power of your amplifier. This increasing could
cause that the amplifier run into the clipping range. This
events when more loudspeakers are connected in a parallel-
operation-circuit to the amplifier.
Please observe also the minimum impedance of the installed
amplifier
IMPORTANT NOTE: The subwoofer enclosures have
no integrated limiter or clipper, which is limiting the level
upwards. Overamplified bass peaks leads inevitably to a
burn out of the voice coil of the woofer. A burn out of the
voice coil, caused by clipping/overamping is not covered by
the usual warranty.
IMPORTANT NOTES
Choose a suitable location for your sound system, that
neither the driver`s field of vision or the security of the
inmates will be affected. This stands also for airbag-zones
and safety belts. The permanent temperature of the location
should not be lower than 5°C ant not higher than 50°C.
Protect the device from moisture an humidity.
Ensure that your subwoofer enclosure will not get loose
during the drive an hurt someone in the passenger cabin. It
is recommended, that you mount the subwoofer enclosure
with suitable belts or any other mounting solutions in the
trunk area.
Please observe not to damage any serial components of your
vehicle (airbags, wires, gas tank, etc.) during the installation
of your sound system by drilling or any other operations.
Never screw or mount any other devices (amps, caps etc.)
onto the subwoofer enclosure, this may cause damage to
the electricity.
NOTE
Before you start with the installation of the sound system, disconnect necessarily the GROUND connection wire
from the battery to avoid any risk of electric shocks and short circuits.
For your personal concerns you should choose a appropriate
sound level for the subwoofer enclosure, that neither the
roadworthy of the driver or his concentration will be disturbed,
that he is able to notice possible traffic noises and acoustical
warning signals.
Modern car audio sound systems provide very high acoustic
pressure beyond the 100dB mark. Please observe in this
case, that permanent use of high sound levels may cause
damage to your ability of hearing.
Please ensure by any means the correct polarity of all
connections. Faulty installed and connected devices may
get damage the vehicle and the device permanently.
Please check in any case the operation guide or wiring
manual of your amplifier which you'd like to use for the
sound system.
Never connect the speaker terminals with the 12 Volt power
supply, otherwise the speakers may get damaged.
INTERCONNECTION
RXS 1000
200 WATTS RMS · 400 WATTS MAX.
IMPEDANCE 4 OHMS
Loudspeaker Outputs
Amplifier 4 Ohms
DISPOSAL/RECYCLING
If you have to dispose the device, please note that no
electronic devices must be disposed in the household
waste. Dispose the device and its components at a suitable
recycling facility in accordance with local waste regulations.
If necessary, consult your local authority or dealer. More
information at www.audiodesign.de/english/disposal
ENG